Schaff Piano Product Catalog - page 68

68
OTHER JARAS BEST SELLERS
HEAT CONTROL UNIT
Will control the watts generated from any 120 volt tool
up to 400 total watts.
No. 906 -
Heat Control Unit. Each
JARAS SHANK AND HAMMER CLAMP
This is an entirely new tool made of lightweight aluminum
measuring 20 inches in length, enough so an entire section of
shanks or hammers can be clamped at one time. There is a
rubber cushion inlay on each side of the jaws to prevent
marring of the hammer shanks. This clamp can be used for
three different operations: shaping and roughing of grand
hammer tails; cleaning old glue irregularities from hammer
shanks; and dressing the striking surface of the felt hammers.
The Jaras clamp is a lifetime tool that will drastically reduce
the time needed to do these three operations.
No. 890 -
Jaras Shank and Hammer Clamp. Each
JARAS ELECTRIC KEY BUSHING CLOTH REMOVER
Never before has there been a tool available to the piano
technician to easily remove key bushing cloth (see insert A).
Simply wet the felt bushing and insert the heated copper tip
of the gun. Within a few seconds the steam will allow the
bushing to be removed. So that the tool will not have to be
continually unplugged to prevent overheating it is suggested
that our No. 906 heat control unit be purchased.
No. 909 -
Bushing Cloth Remover. Each
JARAS UPRIGHT ACTION HOLDER
This Jaras tool was developed for holding the action in place
to prevent tipping (see insert). Two units can be used on
either end of the action, but only one is really necessary. The
holder can be clamped to a table for added stability. Width of
the holder should accommodate any type of action bracket,
while the length is fully adjustable with 4 clamp positions on
one end and a threaded screw assembly in front. Tool is
made of aluminum and stainless steel, measures 10-1/2”
long, weight 15 oz. Will last a lifetime.
No. 886 -
Jaras Action Holder. Each
0...,58,59,60,61,62,63,64,65,66,67 69,70,71,72,73,74,75,76,77,78,...186
Powered by FlippingBook