Schaff Piano Product Catalog - page 49

49
SOUNDBOARD REPAIR CLAMP
A small hole is drilled in both the replacement rib and
soundboard, thereby allowing the piece of music wire to be
extended and secured on top of the rib by the small locking
nut. The plastic dowel, washer and wing nut are then secured
against the soundboard. Order several of these clamps to
reduce the time needed for repairing ribs.
No. 58 -
Soundboard Repair Clamp. Each
TECHNICIAN’S TOOLS
Brilliant Light Rays Clearly
Reflect Image On
Hard-To-Reach Areas.
CONDUCT-A-LITE
A unique, lightweight, all aluminum lighting tool to help with
inspection of any hard-to-see area in a piano, organ, etc. Kit
includes a 6” straight and 4” curved (24°) conductor, a
15/16” diameter clip on mirror, as well as a two cell flash lite
that uses two AA batteries (not included).
No. 57
-
Conduct-A-Lite. Each
No. 57A -
AA Batteries (2 needed for lite). Each
Curved Attachment
For Around Corners
BRIDGE CHISELS
The offset design allows for these chisels to be positioned flat
to exert pressure at the glue joint.
No. 573 -
Bridge Chisel, 6-3/4” long. Each
No. 574 -
Bridge Chisel, 8-1/2” long. Each
HAMMER CHECKERING FILE
This is an 8” long file, imported from Switzerland, that is used
for cutting horizontal grooves on grand hammer heels. File is 8”
long, 3/4” wide.
No. 98 -
Hammer Checkering File. Each
GRAND HAMMER HEAD RASP
Measuring 6“ long, this round tapered rasp is used for
cleaning glue out of hammer head holes before installing
new shanks.
No. 138 -
Grand Hammer Head Rasp. Each
GRAND HAMMER HEAD REAMER
Both of these tapered reamers are used for fitting grand
hammer heads to hammers shanks. Reaming the hammer
head is much easier than reducing the shank diameter.
Reamer is 4” long.
No. 139 -
Reamer with square end for No. 989
Tap Wrench. Each
No. 139A -
Reamer with chuck end for No. 26
Combination Handle. Each
HAMMER SHANK KNURLER
Hammer shanks can be knurled quickly, evenly and
efficiently with this compact, well made tool that can be
secured to your workbench. Tool is adjustable for any shank
diameter as well as the length of the knurl.
No. 217 -
Hammer Shank Knurler. Each
BASS STRING TWISTING TOOL
After putting the tip of the tool into the loop of the bass
string, twist the string, and then place the recessed tip on top
of the hitch pin. By pressing downward, the spring action of
the tool allows the tip to retract, and the loop will be forced
into place on the hitch pin. Tool has a finished hardwood
handle and is 6” in overall length.
No. 262 -
Bass String Twisting Tool. Each
0...,39,40,41,42,43,44,45,46,47,48 50,51,52,53,54,55,56,57,58,59,...186
Powered by FlippingBook